User's Manual

305
Users Manual of CS-6306R
Configuring switch S8:
The following commands are used to set the sub-ring transit node, node 4:
Switch_config#mether-ring 4 domain 1
Switch_config_ring4# transit -node
Switch_config_ring4#sub-ring
Switch_config_ring4#control-vlan 2
The following commands are used to set the time related parameters:
Switch_config_ring4#pre-forward-time 12
Exits from the node configuration mode:
Switch_config_ring4#quit
The following commands are used to set the transit port of node 4:
Switch_config#interface gigaEthernet 0/1
Switch_config_g0/1#mether-ring 4 domain 1 transit -port
Switch_config_g0/1#switchport mode trunk
Switch_config_g0/1#quit
Switch_config#interface gigaEthernet 0/2
Switch_config_g0/2#mether-ring 4 domain 1 transit -port
Switch_config_g0/2#switchport mode trunk
Switch_config_g0/2#quit
27.3.4 Unfinished Configurations (to be continued)
 Unfinished basic information configuration: there is one of the ring’s role, the ring’s grade and the
control VLAN unset. One exceptional case is that when a node’s role has configured to be the edge
node or assistant node, the default ring's grade is sub-ring.
 Contradiction of basic information: When a node’s role is edge-node or assistant-node, the default
ring's grade is sub-ring; when the ring’s grade is major-ring, prompt information will appear.
 Sub ring having no corresponding major-ring node: When a node’s role is edge-node or assistant-node,
this node is borne on the major-ring node; if there is no corresponding major-ring node to compulsorily
create the sub-ring edge node or sub-ring assistant node, prompt information will appear (in this case,
you can use the show command to browse the MEAPS state; if you find the basic information is
complete but the state is init, it indicates that the configuration of the ring’s node has not finished).
 Conflicts arising during control VLAN configuration: If the control VLAN, which is configured by a node,
conflicts with other configured nodes, prompt information will appear (in this case, you can use the show
command to browse the MEAPS state; if you find the basic information is complete but the state is init, it
indicates that the configuration of the ring’s node has not finished).
 If a sub-ring node corresponding to a major-ring node is configured, the ID of the sub-ring node must be
bigger than that of the major-ring node; if the sub-ring node’s ID is less than the major-ring node’s ID, the
sub-ring node cannot be created and related prompt information pops out.