User's Manual

171
Users Manual of CS-6306R
7.8.2.3 RMON Alarm Information Configuration
If you click Network Management Config -> RMON -> RMON Alarm -> New, the RMON Alarm page appears.
Figure 8: Configuring the RMON alarm information
The index is used to identify a specific alarm information; if the index is same to the previously applied index,
it will replace the previous one.
The MIB node corresponds to OID.
If the alarm type is absolute, the value of the MIB object will be directly minitored; if the alarm type is delta, the
change of the value of the MIB object in two sampling will be monitored.
When the monitored MIB object reaches or exceeds the rising threshold, the event corresponding to the index
of the rising event will be triggered.
When the monitored MIB object reaches or exceeds the falling threshold, the event corresponding to the
index of the falling event will be triggered.
7.8.2.4 RMON Event Configuration
If you click Network Management Config -> RMON -> RMON Event -> New, the RMON event page appears.
Figure 9: RMON event configuration
The index corresponds to the rising event index and the falling event index that have already been configured
on the RMON alarm config page.
The owner is used to describe the descriptive information of an event.
"Enable log" means to add an item of information in the log table when the event is triggered.
“Enable trap” means a trap will be generated if the event is triggered.