Quick Guide

8
z Console Port
The console port is an RJ45 type, RS-232 male serial port connector. It is an
interface for connecting a terminal directly. Through the console port, it provides
rich diagnostic information including IP address setting, factory reset, port
management, link status and system setting. Users can use the attached RS-232
cable in the package and connect to the console port on the device. After the
connection, users can run Putty or Tera Term terminal emulation program to enter
the startup screen of the device.
When the following screen appears, make sure that the COM port should be
conguredas:
 Baud Rate: 9600
 Data Bits: 8
 Parity: None
 Stop: 1
 Flow Control: None
z USB Interface
The USB port is a USB2.0 type interface for storage device use.
z MGMT Port
The MGMT port is an RJ45 type independent interface for Telnet or SSH, and
default IP address is 192.168.1.1
z LEDs
The CS6-MCU management module. provides 6 LED indicators and their
descriptions are shown below:
LED Color Function
SYS
Green
Lights to indicate that Management Module is running in
normal status.
O Ifthegreenindicatoriso,theboardcanbepulledout.
PWR
Green Lights to indicate that Management Module has power.
O ToindicatetheManagementModulepoweriso.
Fan Alarm
Red Lights to indicate that the fan system is abnormal.
O Iftheredindicatoriso,thefansystemisnormal.
Hot Swap Green Lights to indicate that the MCU can be hot-swappable.