Quick Guide
4
2. Hardware Installation
2.1 Desktop Installation
The Chassis Switch is very heavy and weighs about 30kg when
fully configured. Please carry and install it by two people to avoid
injury.
To install the CS-6306R on a desktop or shelf, simply complete the following steps:
Step 1 Choose a good workbench.
Step 2 Verify that the workbench is strong enough to support the CS-6306R’s
fullyconguredweight.
Step 3 Place your CS-6306R in a location where there are an appropriate power
source and grounding point, and it can be easily operated.
2.2 Module Installation
During the installation, please make sure the device does not slip
from your grasp, or else it may cause damage to the device or
may even hurt the installer. Please also note the hardware must be
placed in the rack properly; if not, the hardware may fall off from
the rack, causing harm to someone nearby. Double-check it after
the installation.
The installation procedure is the same for all modules, as shown below:
Management slots:
Slots 5 and 6 support management module like CS6-MCU. (Slot 5
is Master.)
Switch slots:
Slots 1 to 4 support Switch modules like CS6-S16X and
CS6-S24S8X.