Quick Guide
7
3.2 Rack-mounting Installation
During the installation, please make sure the device does not slip
from your grasp, or else it may cause damage to the device or
may even hurt the installer. Please also note the hardware must be
placed in the rack properly; if not, the hardware may fall off from
the rack, causing harm to someone nearby. Double-check it after
the installation.
To install the CS-6306R in a 19-inch standard rack, follow the instructions
described below.
Step 1 Place your CS-6306R on a hard at surface, with the front panel
positioned towards your front side.
Step 2 Secure the brackets tightly on the CS-6306R as shown in Figure 3-1.
Figure 3-1 Rack-mounting Brackets
You must use the screws supplied with the mounting brackets.
Damage caused to the parts by using incorrect screws would invali-
date your warranty.