Quick Guide
11
3.5 Removing and Installing the Dust Gauze
Dustgauze is providedin theCS-6306R, whichcan beinstalled and removed from
the back of the CS-6306R in right section. The dust gauze is meant to prevent
large debris or particles in the air from being ingested into the Chassis Switch.
Please perform cleaning on a regular basis according to the site conditions.
Follow steps below:
Step 1 Loosen the 2 panel fasteners in the dust gauze.
Step 2 Draw the dust gauze out smoothly by holding the 2 screws.
Step 3 Clean the dust gauze with a brush (never wash with any liquid).
Step 4 Insert the gauze back to its original position in the Chassis Switch.
Step 5 Tighten the panel fasteners.
The installation and removal of the dust gauze is shown below:
Figure 3-4 IInstallation and Removal of the CS-6306R Dust Gauze