User Manual

Industrial Renewable Energy 4-Port 10/100/1000T
802.3at PoE+ Managed Ethernet Switch
BSP-360
63
Object Description
Enable DoS Prevention
Check to enable DoS function.
User may set other related configurations about DoS below.
Table 4-4-11: Descriptions of the DOS Objects
4.4.5 Route
There are two route types that are Dynamic Route and Static Route. Please refer to the following sections for
the details as Figure 4-4-17 is shown below:
Figure 4-4-17: Route Setup Menu
4.4.5.1 Dynamic Route
Dynamic routing is a networking technique that provides optimal data routing as the screen in Figure 4-4-18
appears. Unlike static routing, dynamic routing enables routers to select paths according to real-time logical
network layout changes. Table 4-4-12 describes the Dynamic Route Objects Screen of Renewable Energy
Switch.
Figure 4-4-18 Dynamic Route Setup Web Page Screen
Object Description
Enable Dynamic Route
Click this box to enable Dynamic Route.
Table 4-4-12: Descriptions of the Dynamic Route Objects
4.4.5.2 Static Route
Static routing is a special type of routing that can be applied in a network to reduce the problem of routing
selection and data flow overload caused by routing selection so as to improve the packets forwarding speed.
You can set the destination IP address, subnet mask, and gateway to specify a routing rule as the screen in