User Manual

Industrial Renewable Energy 4-Port 10/100/1000T
802.3at PoE+ Managed Ethernet Switch
BSP-360
54
4.4.2 LAN
You can configure LAN connection type manually here and see the LAN Statistics here as Figure 4-4-5 is
shown below:
Figure 4-4-5: LAN Interface Menu
4.4.2.1 LAN Setup
This page is used to configure the parameters for local area network which connects to the LAN port of your
Access Point as the screen in Figure 4-4-6 appears. Table 4-4-3 describes the LAN Objects Screen of
Renewable Energy Switch. Here you may change the setting for IP address, subnet mask, DHCP, etc...
Figure 4-4-6: LAN Interface Setup Web Page Screen
Object Description
IP Address
The LAN IP address of the Renewable Energy Switch and default is
192.168.0.100. You can change it according to your request.
Subnet Mask Default is 255.255.255.0. You can change it according to your request.
Default Gateway Default is 192.168.0.254. You can change it according to your request.
DHCP
You can select one of Disable, Client, and Server. Default is Server,
that the Renewable Energy Switch can assign IP addresses to the
computers automatically.
DHCP Client Range
For the Server mode, you must enter the DHCP client IP address range
in the field. And you can click the “Show Client” button to show the
Active DHCP Client Table.