User Manual

Industrial Renewable Energy 4-Port 10/100/1000T
802.3at PoE+ Managed Ethernet Switch
BSP-360
25
Step 3. Install PV Panel
(1) Connect the negative electrode of the PV panel to the terminal for the negative electrode of the PV
panel on the BSP-360.
(2) Connect the positive electrode of the PV panel to the terminal for the positive electrode of the PV
panel on the BSP-360.
(3) After the PV is well connected to the BSP-360 and providing 24V or above voltage, the System LED will
blink fast for battery charge if the battery is not full. And Fault LED will turn off.
Be noted for the thickness of electric wire and please refer to the section --
Recommended Use of the Connected Wires in the Quick Installation Guide.
Check the total power consumption of your device and the sunshine duration of your area
from the weather bureau for a proper PV. Improper PV could shorten the battery life or
provide insufficient power to the BSP-360.
The BSP-360 supports a maximum of 45V DC input.
Please link PLANET download center and download BSP360-PV&BAT_calculation
.
The calculation list can help you to select solar panel and battery.