User Manual

Industrial Renewable Energy 4-Port 10/100/1000T
802.3at PoE+ Managed Ethernet Switch
BSP-360
22
2.1.5 Wiring the Digital Output
The 6-contact terminal block connector on the rear panel of BSP-360 and the 3/4 pin is used for Digital
Output. Please follow the steps below to insert wire.
The BSP-360 offers one DO groups. 3 is DO and 4 is GND. Please tighten the wire-clamp screws for
preventing the wires from loosening.
1 2 3 4 5 6
PV+ PV- DO GND Bat+ Bat-
There are one Digital Output groups for you to sense BSP-360 port failure or power failure and issue a high or
low signal to external device. The following topology shows how to wire DO and GND.
2.2 Installing the Renewable Energy Switch
This section describes how to install your Renewable Energy Switch and make connections to the Renewable
Energy Switch. Please read the following topics and perform the procedures in the order being presented.
Please read the following topics and perform the procedures in the order being presented. To install your
Renewable Energy Switch on a desktop or shelf, simply complete the following steps.