User Manual

Industrial Renewable Energy 4-Port 10/100/1000T
802.3at PoE+ Managed Ethernet Switch
BSP-360
19
Item Interface Description
1 Port-1~Port-4
4 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports with 802.af/at PoE+
injector function.
2 Port-5
One 10/100/1000BASE-T RJ45 auto-MDI/MDI-X port.
Port-5 functions as WAN port when the operation mode of BSP-360 is
configured to “Gateway mode”
3 USB
Connect the USB storage to USB port and back up the configuration file.
4 Reset Button
< 5 seconds: System reboot.
> 5 seconds: Factory default.
5
4-pin T
erminal
Block
24V DC output connector.
The output voltage is the same as battery voltage.
Maximum voltage is clamped at 24V, 1A.
2.1.2 LED Indicators
The front panel LEDs indicates instant status of system power, PoE and PV system failure, management port
Link/Active, PoE power usage status and per PoE port links status, thus helping administrator to monitor and
troubleshoot when needed.
System
LED Color Function
PWR Green On
To indicate BSP-360 has power.
Fault Green
Slow Blinks To indicate the PV is disconnected.
Fast Blinks
To indicate the battery voltage is less than the value for
low‐voltage disconnection.
On To indicate bad battery, over-current or short-circuit.
PV System Green
Slow Blinks To indicate the system is “on”.
Fast Blinks To indicate the battery is “charging”.
50W Green On
To indicate the system consumes over 50-watt
PoE power
budget.
100W Green On
To indicate the system consumes over 100-watt
PoE power
budget.
120W Green On
To indicate the system consumes the total 120-watt
PoE power
budget.
PoE 10/100/1000BASE-T Interfaces (Port-1 to Port-4)
LED Color Function
LNK/ACT Green Blinks
To indicate the link through that port is successfully established.
PoE Orange Lights
To indicate the port is providing DC in-line power.