Quick Guide

9
Battery In/Out
24V DC
Battery DC Input: 24V , 10A
PV DC Input: 24-45V
, 8.8A max.
Max.
Fault Alarm Loading: 24V, 1A
V+
PV
Bat.
Alarm
V+
Warning
Please make sure the V+ & V is connec ted correctly,
and the wire gauge meets the maximum current.
1 2 3 4 5 6
Battery
24V DC
DC
DC
Note
The wire gauge for the terminal block should be in the range from
16 to 20 AWG.
Fault Alarm Connectors
The fault alarm contacts are in the middle (3 & 4) of the terminal block connector
as the picture shows below. Inserting the wires, the Renewable Energy Switch will
detect the fault status of the power failure.
*When the system is “ON”, the fault alarm is “o”.
*When the system is “OFF”, the fault alarm will “trigger”.
1 2 3 4 5 6
Load
5~24VDC
GND