ADN-4000 802.11n Wireless ADSL 2/2+ Router Quick Installation Guide

3. Connect ADSL Cable

Connect the supplied ADSL cable from to the WAN port on the ADN-

4000 (the RJ-11 connector) to the ADSL terminator provided by your

phone company.

4. Power Up

Connect the supplied power adapter to the ADN-4000. Use only the

power adapter provided. Using a different one may cause hardware

damage.

5. Check the LEDs

• The PWR LED should be ON.

• The WLAN LED should be ash, when wireless AP is ready.

• The ADSL LED should be ON if ADSL line is connected.

• For each LAN (PC) connection, one of the LAN LEDs should be ON

(provided the PC is also ON.)