User's Manual

The page includes the following settings
Object
Description
• SNMP
Enable or disable the SNMP service.
• Contact
Enter the contact details of the device.
• Location
Enter the location of the device.
• Community Name (Read
Only)
Enter the
access.
• Community Name
(Read/Write)
Enter the
write access.
• Trap Destination Address
Enter the IP address
• Trap Destination
Community Name
Enter the
• SNMPv3
Enable or Disable the SNMPv3 feature.
• User Name
Specify the username for SNMPv3.
• Auth Protocol
Select the authentication protocol type: MD5 or SHA.
• Auth Key (8-32 Characters)
Specify the authentication key for authentication.
• Priv Protocol
Select the privacy protocol type: DES.
• Priv Key (8-32 Characters)
Specify the privacy key for privacy.
• Engine ID
Specify the engine ID for SNMPv3.
• Save/Apply
Click
• Cancel
Click
4.6.4
Backup/Restore Settings
Click “Management

Backup/
Restore
Figure
User Manual of
WAP
-65-
The page includes the following settings
:
Description
Enable or disable the SNMP service.
Enter the contact details of the device.
Enter the location of the device.
Enter the
password
for accessing the SNMP community for
access.
Enter the
password for accessing the SNMP community for
write access.
Enter the IP address
where SNMP traps are to be sent.
Enter the
password of the SNMP trap community.
Enable or Disable the SNMPv3 feature.
Specify the username for SNMPv3.
Select the authentication protocol type: MD5 or SHA.
Specify the authentication key for authentication.
Select the privacy protocol type: DES.
Specify the privacy key for privacy.
Specify the engine ID for SNMPv3.
Click
Save/Apply to apply all changes.
Click
Cancel to cancel the settings.
Backup/Restore Settings
Restore
Settings” and the following page
will be displayed.
Figure
4-43 Backup/Restore Settings
WAP
-500N/WBS-500N
for accessing the SNMP community for
read-only
password for accessing the SNMP community for
read and
where SNMP traps are to be sent.
password of the SNMP trap community.
Select the authentication protocol type: MD5 or SHA.
will be displayed.