User's Manual

Scroll through the FILTER Menu until
the Empty Breech Detection Time
(EMPTY) option is displayed.
The current value of the Empty Breech
Detection Time (EMPTY) is displayed
on the right hand side of the display.
Press the Select pushbutton to enter the
edit function and the edit indicator will
appear on the display.
Press and release the Raise pushbutton
to increase the Empty Breech Detec-
tion Time (EMPTY) in 0.1 millisecond
increments. Press and hold the Raise
pushbutton to increase the Empty
Breech Detection Time (EMPTY) more
rapidly.
Press and release the Lower pushbutton
to decrease the Empty Breech Detec-
tion Time (EMPTY) in 0.1 millisecond
increments. Press and hold the Lower
pushbutton to decrease the Empty
Breech Detection Time (EMPTY) more
rapidly.
Press Select to save the Empty Breech
Detection Time (EMPTY) and the edit
indicator will disappear from the display
to indicate that the value has been ac-
cepted.
SETTING THE EMPTY
BREECH DETECTION TIME
The trigger has to be pulled for a specic
time in order for that trigger pull to be ac-
cepted as a valid trigger pull. The marker
cannot be red until it has had a valid
trigger pull.
The trigger then has to be released for a
specic time in order for that release to
be accepted as a valid trigger release.
The marker cannot be red again until
it has rst had a valid trigger release
(followed, of course, by another valid
trigger pull).
With the addition of the Trigger Transi-
tion software lter, you can minimise
the amount of time for which the trigger
has to be pulled and released in order to
maintain high rates of re whilst eliminat-
ing the risk of “bounce”.
USING THE TRIGGER FILTERING
Advanced Set-Up
32
Advanced Set-Up
33