User's Manual

To activate the SET-UP Menu, rst
remove the three rubber grip screws
from the right hand side of the frame and
peel back the rubber grip to expose the
Zero.B board inside the frame. Press
and hold the Set-up pushbutton, which is
located on the PCB above the battery.
After one second, TIMING will be
displayed - this is the rst option on the
SET-UP Menu as shown below:
Press the Lower pushbutton to scroll
down through each of the options on the
menu. Once the last option has been dis-
played, pressing the Lower pushbutton
will cause the rst option to be displayed.
Press the Raise pushbutton to scroll up
through each of the options on the menu.
Once the rst option has been displayed,
pressing the Raise pushbutton will cause
the last option to be displayed.
Press the Select pushbutton to select the
displayed option.
Selecting BACK will return the display to
the Run Screen from which the SET-UP
Menu was selected.
THE SET-UP MENU
Advanced Set-Up
22
Advanced Set-Up
23