User's Manual

INSTALLATION CONTINUED..





underside of your Etek or Etek2 body as shown in

FIGURE

1.7

. Using a pair of snips, cut the low pressure hosing

from the barb on the Front Regulator Mount (FRM) so

that the solenoid assembly can be removed completely

from the marker body

(SEE FIGURE 1.8).

Cut the low pressure hose free from the two banjo barb



minifold and discard, leaving the solenoid and minifold

assembly and two banjo barbs

(SEE FIGURE 1.9)

SUPER IMPORTANT NOTE: IF YOU ARE NOT FITTING THE

ETEK QEV, USE THE HOSE LENGTH TEMPLATE AT THE

BOTTOM OF PAGE 53

Referring to the hose length template at the top of page

53 of this manual, take the coil of low pressure hosing

that is included in your Etek STAR frame kit and cut the

three lengths of hosing that are required

(SEE FIGURE 1.10)

FIG 1.8

FIG 1.10FIG 1.9

FIG 1.7

FIG 1.6

INSTALLATION