User's Manual

INSTALLING THE ETEk STAR

FRAmE ONTO AN ETEk AND AN

ETEk2 mARkER



Etek or Etek2 Paintball marker. The following installation

guide can be applied to either marker, but if you have



your Etek/Etek2 marker then you should contact your

nearest Eclipse Service Centre for advice. Full details of

Eclipse Service Centres can be found on pages 50 and

51 of this manual.

De-gas your marker and discharge any stored gas in a

safe direction before proceeding. Remove the loader,

barrel and air tank so that you can comfortably work on

the marker. Disconnect the 1/4” Macroline hosing from

both the elbow attached to the Inline Regulator and the

elbow attached to the OOPS at the base of your existing

grip frame. Remove the Inline Regulator by unscrewing

it from the front regulator mount (FRM) and the marker

should now resemble

FIGURE 1.1

. Using a 5/64” hex key

remove the three countersunk screws from the right

hand side of the rubber grip

(SEE FIGURE 1.2)

and peel

back the rubber grip to reveal the inside of the grip

frame

(SEE FIGURE 1.3)

Unplug the solenoid from its connector on the circuit

board, unplug the Break Beam Sensor System (BBSS)

from its connector on the circuit board

(SEE FIGURE 1.4)

Using a 1/8” hex key undo and remove both frame

screws by turning them in a counter-clockwise direction

(SEE FIGURE 1.5)

. At this stage your existing frame can

now be removed from the marker body and set aside

for later use, leaving the marker body with the solenoid

assembly still attached as shown in

FIGURE 1.6 ON THE

NExT pAGE.

FIG 1.2FIG 1.1

FIG 1.4 FIG 1.5

FIG 1.3

INSTALLATION