User's Manual

THE HARDWARE mENU
The HARDWARE Menu comprises parameters that
control low level functionality of the Etek STAR Frame
electronic hardware.
THE TRIGGER pARAmETER
(TRIGGER)

detection system. A non-contact opto-electronic trigger
sensor arrangement is used to detect trigger movement
whilst a micro-switch is used to provide a more
traditional tactile feedback for the trigger. The TRIGGER
parameter is used to select which system is used. The
choices available are as follows:-
> OpTO: Select the Opto sensor for trigger pull detection.
> SWITCH: Select the micro-switch for trigger pull
detection.
> CANCEL: Cancel editing and leave the parameter
unchanged.
THE bbSS pARAmETER (bbSS)
This parameter controls the amount of power used by
the Break Beam Sensor System and should normally be

on the surface of either of the sensors, or the use of
some third party sensors, may require that the BBSS

more drain on the battery. The choices available for this
parameter are:-
> LO pOWER: Low power BBSS drive
> HI pOWER: BBSS drive
> CANCEL: Cancel editing and leave the parameter
unchanged
THE AUxILIARY OUTpUT
pARAmETER (AUx OUT)
The auxiliary output is on a three pin connector in
the circuit board and is used to provide an interface
between the Etek STAR Frame and third party
equipment such as loaders. The AUX OUT parameter
is used to enable the auxiliary output which pulses

choices are:-
> OFF: Auxiliary output off.
> ON: Auxiliary output on.
> CANCEL: Cancel editing and leave the parameter
unchanged.
NOTE: 
then the output on that board is pulsed at the same time
as the auxiliary output.
48.
ADvANCED SET-Up