User's Manual

SETTING THE TRIGGER CONT...

The Magnet Return Strength Screw is used to adjust the

amount of force with which the trigger is returned to its

rest position by the magnet. Turn the screw clockwise to

increase the amount of force. Do not turn the screw too

far or it will negate the position of the Front Stop Trigger

Screw. Turn the screw counter-clockwise to reduce the

amount of force. Do not turn the screw too far or there

will not be enough force to return the trigger

(SEE FIGURE

4.3).

The Micro Switch Activation Screw is used to adjust the

point in the trigger pull at which the micro-switch is

activated. Turn the screw clockwise to decrease the

amount of trigger travel to the activation point. Turn

the screw counter-clockwise to increase the amount of

trigger travel to the activation point

(SEE FIGURE 4.4).

If you have selected SWITCH from the HARDWARE Menu

and are consequently using the micro-switch as the

method of trigger detection then check that the micro-

switch activates and de-activates fully on each trigger

pull and trigger release. If you have selected OPTO from

the HARDWARE Menu and are using the OPTO sensor as

the method of trigger detection, refer to setting the BAND

and BAND LO

(SEE pAGE 45-46)

as it is crucial that the





FIG 4.3

FIG 4.4

19.

USING YOUR ETEk STAR FRAmE