User's Manual

SETTING THE TRIGGER
The Etek STAR Frame provides the user with the
option to use either a Micro-Switch or an opto sensor
as the means for detecting trigger pulls. Before you

select the method of trigger detection that you wish
to use by entering the Set-Up Menu and making your
 (SEE pAGE 48).
There are four adjustment points on the trigger – the
Front Stop Trigger Screw, the Rear Stop Trigger Screw,
the Magnet Return Strength Screw and the Micro Switch
Activation Screw
.
As standard each Etek STAR Frame comes with a
factory set trigger travel of approximately 2mm in total


trigger detection method set to opto.
The Front Stop Trigger Screw is used to set the amount

clockwise to reduce the amount of travel. Do not turn
the screw too far or the trigger will be pushed past the

counter-clockwise to increase the amount of trigger
travel (SEE FIGURE 4.1).
The Rear Stop Trigger Screw is used to set the amount

clockwise to reduce the amount of travel. Do not turn
the screw too far or the trigger will be prevented from

Turn this screw counter-clockwise to increase the
amount of travel (SEE FIGURE 4.2).
FIG 4.2
FIG 4.1
18.
USING YOUR ETEk STAR FRAmE