User's Manual

SWITCHING ON THE ETEk

STAR FRAmE

Press and hold the button

(SEE FIGURE 3.1)

. After one

second the Etek STAR Frame logo will be displayed.

Release the button and the Run Screen will be

displayed.

SWITCHING OFF THE ETEk

STAR FRAmE

Press and hold the button until the display shows

OFF? Release the button and re-press it to turn off the

Etek STAR Frame. Alternatively when the display reads

OFF?, you can pull the trigger once to turn off the Etek

STAR Frame.

FIRING THE ETEk STAR FRAmE





STAR Frame circuit board, enabling any user to easily



THE ETEk STAR FRAmE

CIRCUIT bOARD

There are three sockets on the Etek STAR Frame

Circuit board two of which are occupied by the BBSS

Connector (A) and the Etek STAR Frame Solenoid (B).

The third socket on the board (C) is the Auxiliary socket

to which third party products such as loaders and RF

transmitters can be connected using the relevant wiring

harness or parts.

(SEE FIGURE 3.2)

FIG 3.2

FIG 3.1

15.

QUICk SET-Up