User's Manual

INSTALLING A 9v bATTERY
Ensure that the Etek STAR Frame is switched off. Lay

tube furthest away and with the barrel pointing to the
right.
Use a 5/64” (2mm) hex key to remove the three
countersunk screws that hold the rubber grip onto the
frame. Peel the grip to the right to expose the circuit
board within the frame.


battery out of the frame (SEE FIGURE 2.1) .
DO NOT pull on the top of the battery to remove it as this
can cause the battery terminals to bend and will result in
a poor electrical connection.
Fit a 9-volt alkaline battery (type PP3, 6LR61 or
MN1604) into the recess with the battery terminals away
from you. The positive terminal should be on the right
hand side, nearest to the side of the frame (SEE FIGURE
2.2)
.
Ensure that all of the wires are within the recess of
the frame and away from the trigger microswitch and
opto sensors so as not to interfere with their operation
and replace the rubber grip and replace the three
countersunk screws.
DO NOT OVER-TIGHTEN THE SCREWS.
NOTE: bATTERY vOLTAGE mUST NOT ExCEED 10 vOLTS.
SOmE 9 vOLT RECHARGEAbLE bATTERIES CAN ExCEED
THIS vOLTAGE IF OvER CHARGED. IF IN DOUbT DO NOT
USE RECHARGEAbLE bATTERIES.
FIG 2.2
FIG 2.1
14.
QUICk SET-Up