User's Manual

INSTALLATION CONTINUED..
If installing the Etek STAR Frame onto an Etek2, take
the original Etek2 grip frame and use a 3/32” hex key to
loosen the two set screws that attach the OOPS body
to the bottom of the grip frame and remove the OOPS
from the base of the original Etek2 grip frame (SEE FIGURE
1.21)
. The base of the Etek STAR Frame is compatible
with the T-Slot mounting system used on the Etek2 (SEE
FIGURE 1.22)
so taking your Etek2 OOPS slide it onto the
base of the Etek STAR Frame and using a 3/32” hex key
tighten the two set screws to lock the OOPS in place
(SEE FIGURE 1.23) .
If installing the Etek STAR Frame onto an Etek that does
not have a T-Slot mounted OOPS, use a 3/32” hex key
to loosen the set screw inside the original Etek grip
frame that tightens the OOPS body onto the base of
the grip frame so that it can be removed from the rail by
sliding it backwards (SEE FIGURE 1.24) . Slide the dovetail
conversion rail onto the bottom of Etek STAR Frame
and using a 3/32” hex key tighten the two set screws to
secure it in place (SEE FIGURE 1.25 ON THE NExT pAGE) . Slide
the chosen ASA adaptor onto the dovetail conversion
rail and using a 3/32” hex key tighten the two set
screws that secure the ASA adaptor onto the dovetail
conversion rail (SEE FIGURE 1.26 ON THE NExT pAGE) .
FIG 1.24
FIG 1.23FIG 1.22
FIG 1.21FIG 1.20
12.
INSTALLATION