User's Manual

INSTALLATION CONTINUED..



the Etek/Etek2 body (SEE FIGURE 1.11) . Taking the longest
length of low pressure hose, attach one end to the barb

on the minifold; the solitary front barb (SEE FIGURE 1.12) . At


shortest length of low pressure hose to the barb labelled


minifold (SEE FIGURE 1.13). Using a pair of non serrated
needle-nosed pliers attach the shortest hose to the

 (SEE FIGURE 1.14) . Position
the solenoid assembly in the designated area on the
underside of the Etek/Etek2 body in preparation for the
 (SEE FIGURE 1.15)
NOTE: Push all low pressure hose connections rmly
onto the barb tting to ensure an adequate seal.
Replace as necessary if the low pressure hose is
damaged or stretched.
FIG 1.13 FIG 1.14
FIG 1.15
FIG 1.11 FIG 1.12
10.
INSTALLATION