Manual
07
GTEK170R
FIG-1
A
Ensure the marker is switched OFF before you begin.
B
Screw both ends of the barrel together.
Screw the barrel tip counter-clockwise onto the barrel back.
C
Screw the complete barrel to the marker.
The barrel back screws clockwise into the marker body.
D
Fit a barrel blocking device for safety.
E
Ensure the marker is de-gassed.
Push in and hold the POPS button and pull the POPS bonnet away
from the POPS body.
F
Attach the pre-set air system.
Rotate the air system clockwise into the POPS body.
G
Loosen the clamping feed neck.
Open the feed-neck lever away from the feed-neck.
Rotate the feed-neck lever screw counter-clockwise.
H
Attach the loader.
If the feed neck is too tight, loosen the clamping feed neck more.
I
Secure the loader.
Rotate the feed-neck lever screw clockwise to tighten.
Close the feed-neck lever to secure.
J
Gas the marker.
Push the POPS bonnet into the POPS body until it engages.
K
Switch ON the 170R.
1
IMPORTANT! To switch On/O, see pages 8-11.
2
DO NOT over-tighten the barrel.
3
ALWAYS ensure the marker is de-gassed when setting up.
4
NEVER use CO2. Compressed air or Nitrogen only.
5
DO NOT over-tighten the feed neck. This may damage the marker.
QUICK START
SETTING UP THE 170R
WARNING!
Always ensure that the marker is o with a barrel blocking device installed and
that no paintballs are in the 170R or loader before installing an air system.
Compressed air and nitrogen systems can be extremely dangerous if handled
or used incorrectly.
Only attach an air system certied for use within the country of use.
Never add lubricants or grease into the ll adaptor of the air system regulator.
Ensure that all screws are tightened and no parts are loose before installing an
air system.
Do not pressurise the 170R without the bolt system correctly installed, as high
pressure gas will be emitted.
Do not install a compressed air system or load paintballs into the 170R until
you feel condent with your ability to handle the marker safely and responsibly.
WARNING