Manual

29
GTEK170R
FAULT FINDING
FAULT FINDING TABLES
SYMPTOM POSSIBLE CAUSE SOLUTION
Two or more balls are being
fed into the breech.
Worn, damaged or missing ball detents. Change the rubber ball detent.
The feed force is too high from loader. Adjust loader settings/use a lower force loader.
170R is inconsistent.
The inline regulator is supercharging. Strip and clean inline regulator, replace regulator seal.
The DWELL is too low. Increase the DWELL setting.
Poor quality paintballs. Use better quality paintballs.
Poor paintball size to barrel bore match. Use a closer paintball to barrel bore size.
Inconsistent air supply from air system. Use a good quality air system.
170R is inefcient. Poor paintball size to barrel bore match Use a closer paintball to barrel bore size.
When the 170R powers up the
display shows SETUP or LOCKED or the
LED ashes white or red.
The trigger is being pulled. Release the trigger before powering on the 170R.
Microswitch is permanently depressed by an incorrectly
set trigger.
Adjust the trigger so that when the trigger is at
rest the microswitch is not being activated (see page 13).
If an issue with the 170R cannot be solved using the fault nding guide,
contact your nearest Eclipse Service Centre for assistance.