Manual
22
GTEK170R
ELECTRONICS
THE LED SET-UP MODE
If the OLED module is unplugged from the main circuit board it is still
possible to modify the 170R parameters using the LED interface. To enter
the set-up mode:
1
Switch the tournament lock o (page 32).
2
Fully depress the trigger.
3
Switch on the 170R (with trigger depressed).
4
Release the trigger.
5
If the LED ashes red, the tournament lock is still on.
Once in the set-up mode, use the trigger to cycle through the
parameters, indicated by LED colours (see table below). Quickly press
the Select button on any parameter to display the current settings.
LED COLOUR PARAMETER RANGE
RED Pre-set 1 to 4
GREEN
Maximum ROF with BS on
(capped modes only)
4.0 to 15.0 bps
BLUE Maximum ROF with BS off 4.0 to 15.0 bps
PURPLE Dwell 18.0 ms to 28.0 ms
LIGHT BLUE Debounce 1 to 10
A long LED ash indicates the unit, whilst a short LED ash indicates the
tenth. Eg, 5 long ashes and 3 short ashes would indicate 5.3.
Modifying a parameter:
1
Enter the set-up mode.
2
Select a parameter.
3
Push and hold Select button for 1 second to conrm.
4
The LED will go o.
5
Increase the unit value using the trigger, one pull per unit.
Do not pull the trigger if the value should be 0.
1
6
Push the Select button to switch to tenths values.
2
7
Increase the tenths value using the trigger, one pull per tenth.
Do not pull the trigger if the value should be 0.
8
Push the Select button to conrm. The LED will ash 3 times.
The LED will show green if the changes are conrmed.
The LED will show red if the changes are NOT conrmed.
If the LED is red repeat
3
9
To exit set-up mode push and hold the Select button until the LED
starts to ash.
1 The settings will return to their previous saved values if you do not
pull the trigger for 5 seconds.
2 If a parameter does not support tenths, this will be skipped.