Manual

15
GTEK170R
FIG-1
A
Ensure that a barrel blocking device is tted for safety.
B
Switch the marker OFF.
C
De-gas the marker.
Push in and hold the POPS button and pull the POPS bonnet
away from the POPS body.
D
Remove the pre-set air system.
Rotate the air system counter-clockwise from the POPS body.
E
Loosen the clamping feed neck.
Open the feed neck lever away from the feed neck.
Rotate the feed neck lever screw counter-clockwise.
F
Remove the loader.
If the feed neck is too tight, loosen the clamping feed neck more.
G
Remove the barrel from the marker body.
Rotate the barrel counter-clockwise to remove.
H
Remove the barrel tip from barrel back.
Rotate the barrel tip clockwise to remove.
1
IMPORTANT! Extra precaution to avoid injury.
2
IMPORTANT! To switch O/On, see pages 8-11.
3
IMPORTANT! Always de-gas before unloading.
4
IMPORTANT! Always remove air system before unloading.
5
IMPORTANT! Always remove any paintballs from the breech of the
marker once the loader has been removed.
6
IMPORTANT! Rotate the barrel tip CLOCKWISE to remove.
QUICK START
UNLOADING THE 170R
WARNING!
Always make sure the marker is o with a barrel blocking device installed and
that no paintballs are in the 170R or loader before unloading.
Compressed air and nitrogen systems can be extremely dangerous if handled
or used incorrectly.
NEVER leave the 170R gassed up when unloading.
NEVER point your marker in the direction of other people when not on the eld.
Remove any paintballs from the breech before storing your 170R.
WARNING