Manual

FIG-1

GTEK170R

If the OLED board is unplugged from the 170R circuit board it is still

possible to operate the marker.

FIG-1

To switch the 170R on press and hold the Select button

Release the Select button when the LED

lights up and the power

up sequence will begin. At the end of the power up sequence the LED

Indicator will show the status of the breech sensor (see table 1).

1,2

TABLE 1

LED COLOUR BREECH SENSOR (BS) STATUS

FLASHING YELLOW

BS enabled. NO paintball detected.

Marker WILL NOT re.

FLASHING LIGHT BLUE

BS enabled. Paintball detected.

Marker WILL re.

FLASHING PURPLE (SLOW)

BS disabled. Marker WILL re.

FLASHING PURPLE (FAST)

Blockage detected. BS disabled.

Marker WILL re.

To switch the 170R o press and hold the Select button. Release the

Select button when the LED turns red. The 170R will now switch o.

1 When the 170R is turned on, the breech sensor is automatically enabled.

2 The LED colours displayed during the power up sequence may vary depending on which

part of the world the marker was originally purchased.

QUICK START

SWITCHING THE 170R ON/OFF

(LED)