Manual

TheBreakBeamSensorSystem,referredtoelsewhereinthismanual
as‘BBSS’isusedtodetectwhenapaintballisreadytobefiredfrom
theGSL.IfnopaintballisreadythentheBBSSwillinhibittheGSL
fromfiring.ThispreventstheGSLfrom“chopping”paintballsthatare
notfullyloadedintothemarker.
1


ToswitchofftheBBSS,pressandholdthe
buttonfor0.5seconds
(SEEFIGURE4A) .TheBBSSindicatoronthetoprightoftheLCDwill
changefrom
(enabled)to (disabled).

ToswitchtheBBSSbackon,pressandholdthe
buttonfor0.5
second.Theindicatorwillchangebackto
.

WhentheBBSSisenabled,theindicatorwillchangedepending
uponwhetherthesystemhasdetectedaballornot.Whennoball
hasbeendetectedtheindicatorwilllooklikethis
.Whenaballhas
beendetectedtheiconchangestolooklikethis
.

AdditionalfeaturesoftheGSL’sBreakBeamSensorSystemare
coveredinfullonpage23ofthisoperatorsmanual.















1
When the GSL is turned on, the BBSS is automatically enabled.
Using THE BrEaK BEaM
sEnsor sYsTEM
FIG4A
Using THE gsL 9