Manual

TheGSLdegassesveryslowly.
TheGSLleaksfromthesolenoidassembly.








GSLleaksdownthebarrel.





Gasventsquicklydownthebarrelassoonas
theGSLisgassedup.

TheGSLischoppingortrappingpaint.
Thebodyfilterisblocked/damaged.
Checkthatthethreesolenoidgasketsare
intactandseatedintheirdesignatedpockets
bothinandaroundthesolenoidmanifold.
GSLsolenoidassemblyisover-pressurising.
Debrison/damagetopoppet.
DamagedGSLsolenoidvalve.
Frontorrearpropshaft14x2NBR70o-rings
aredamaged,dirtyordry.
Internal017NBR70o-ringandexternal020
NBR70o-ringsonboltcanaredamaged,dry
ordirty.
Theboltisstuckinaforwardposition.
Mainpropshaft014x2o-ringisdamagedor
anincorrectsize.
Theloaderhastoohighaforcefeedsetting.
Poorqualitypaintballs.
Thebreakbeamsensorsystemisswitched
off.
Theboltisdirtycausingtheincorrect
detectionofpaintballs.
Cleanthebodyfilterandinspectfordamage.
Replaceifdamaged.
Replaceanyofthesolenoidgasketsifthey
aredamaged.

Checktheinlineregulatoroutputpressure
andconsequentvelocity.Adjustaccordingly.
StripandcleantheSL4inlineregulator.
Replacingthesealsasnecessary.
Clean/replacethepoppet.
ReplacetheGSLsolenoidvalve.
Replace,cleanandlubricate14x2NBR70
o-ringsonpropshaft.
Replace,cleanandlubricate017NBR70
o-ringand020NBR70o-ringsonthebolt
can.

Pushtheboltbackwards.
Replacewithanew014x2sizeo-ring.

Adjusttheloadertoalowerforcefeed
setting.
Usebetterqualitypaintballs.
Switchonthebreakbeamsensorsystem.

Cleantheboltandbreach.
SYMPTOM POSSIBLE CAUSE SOLUTION
FaULT FinDing 63