Manual

TheGSLdoesnotfire.


TheGSLdoesnotcyclefully.
TheGSLisinconsistent.
TheGSLisinefficient.
TheGSLhaslowrateoffire.

Themicro-switchisnotbeingactivated.


Themicro-switchisdamaged.

ThePCBisdamaged.
Thesolenoidvalveisdamaged.
Thesolenoidvalvewiresaredamaged.
Theboltassemblyisdirtyorincorrectly
lubricated.
TheDwellparameterissettoolow.
Astickyorfaultypoppetinthesolenoid
manifold.
TheDwellparameterissettoolow.
TheSFRissettoolow.
Usingpoorqualitypaintballs.
Apoorpaintballtobarrelborematch.

Theinlineregulatorissupercharging.

Dirtybodyfilter.
Poor/inconsistentairsupplyintoPOPS.
TheDwellisexcessivelyhigh.
Thesolenoidflowrestrictorissettoolow.

Theforcesettingontheloaderistoolow.
Adjustthemicro-switchactivationscrew
accordingly.

Replacethecircuitboard.
Replacethesolenoidvalve.

Clean,re-lubricateandreplacetheo-ringson
theboltasnecessary.
IncreasetheDwellparameter.
Checkthepoppet,cleanandreplaceas
necessary.
IncreasetheDwellparameter.
IncreasetheflowthroughtheSFR.
Usebetterqualitypaintballs.
Useabetterpaintballtobarrelboresize
match.
Stripandcleaninlineregulator.

Stripandcleanthebodyfilter.
Useagoodqualitypresetairsystem.
ReducetheDwell.
IncreasetheamountofflowontheSFR.

Adjusttheloaderforcefeedsetting.
SYMPTOM POSSIBLE CAUSE SOLUTION
62 FaULT FinDing