Manual

Althoughafreshbatteryhasbeenfitted,the
GSLwillnotswitchon.
Thebatterydoesnotseemtolastverylong.

TheGSLdoesnotfire.
Thebatteryhasbeenfittedincorrectly.
Thebatteryhasdrainedontheshelf.
Thebatteryterminalsarenotmakingproper
contactwiththebattery.
Thebatterytypeisofalowquality.
ThePOPSisnotengaged.
Solenoidflowrestrictor(SFR)settoolow.
TheSFRassemblyisblocked.
Batteryqualityorlevelofchargeisverylow.
Batteryisflat.
TrainingModeisenabled.
Triggerandtriggerdetectionmethodareset
upincorrectly.
Triggerdetectionsystemisblocked.
SolenoidassemblyisnotpluggedintoGSL
PCBcorrectly.
Thebreakbeamsensorsystemisenabled
buttherearenopaintballsinthebreech.

Fitthebatterycorrectlywiththepositive
terminalnearesttothesideoftheframe.
Replacewithanotherfreshbattery.
Removethebattery,gentlybendthe
terminalstowardswherethebatterywillsit
andthenreplacethebattery.

Useanalkalineormetalhydridebattery.Do
notusealowqualityorrechargeablebattery.
EngagethePOPSfully.
IncreasetheflowthroughtheSFR.
StripandcleantheSFRassembly.
Installnewhighqualitybattery.
Installnewhighqualitybattery.
Disabletrainingmode.
Setupthetriggercorrectly(referto“Setting
thetrigger”section).

Removeanywiresordebrisfromthetrigger
detectionsystem.
Plugsolenoidassemblyplugintothesolenoid
portontheGSLPCB.

Filltheloaderwithpaint/turnonloader.


POSSIBLE CAUSE SOLUTIONSYMPTOM
TheFaultFindingguidecoverscommonsymptoms,causesandsolutionsthatarelikelytobeencounteredbytheaverageuser.Ifaissuewith
theGSLcannotbesolvedusingtheFaultFindingguide,contactyournearestEclipseServiceCentreforassistance.
FaULT FinDing 61