Manual

BeforeusingtheGSLitisimportanttomakesuretheSL4inline
regulator,solenoidflowrestrictor(SFR)andallelectronically
controlledparametersaresetcorrectly.Allofthesecanhavea
negativeeffectontheperformanceofthemarkerifsetincorrectly.

ThestepsbelowwillrestoretheGSLsettingstothefactorysettings.
ThesesettingswillgivetheGSLamorebalancedperformance,ideal
fortheaverageuser.

INLINEREGULATOROUTPUTPRESSURE
Checktheinlineregulatoradjusterscrewissetto4
1/2
turnsclockwise
fromitsmaximumoutposition (SEEFIGURE1A) .Thiswillensurethe
SL4inlineregulatorissettoanoutputpressurethatwillnotdamage
theGSLwhensuppliedwithcompressedair/nitrogen(seepage18
formoreinformationonSL4inlineregulatoradjustment).

SOLENOIDFLOWRESTRICTORSETTINGS
Checkthatthesolenoidflowrestrictor (SEEFIGURE1B) issetas
pictured.Seepage19formoreinformationonthesolenoidflow
restrictor.

ELECTRONICALLYCONTROLLEDPARAMETERS
LoadtheFACTORYpreset (SEEFIGURE1C) storedontheGSLcircuit
board.Thispresetwillrestorealltheelectronicparameterstotheir
defaultsettings.Seepage29onloadingtheFACTORYpreset.
FaCTorY sET-UP gUiDE
FIG1A
FIG1B
FIG1C
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PAINTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
6 Using THE gsL