Manual

Toinstalltheframe,firstlychecktheSFRsealiscorrectlylocated
inthetopoftheframe (SEEFIGURE22A) ,thencarefullythreadthe
solenoidandtheBreakBeamSensorSystemwiringharnesses
throughtheaccessholeinthetopoftheframeandlinetheframeup
sothattherearframescrewsitsintheaccesshole
(SEEFIGURE22B) .

BecarefulnottotraporpinchtheBBSSorsolenoidwiresbetween
thebodyandframe.

SlidetheframeforwardsothatitsitscompletelyflushwiththeGSL
bodyandusingtheshortarmofa1/8”hexkey,tightentherearframe
screwintoplace
(SEEFIGURE22C) .Checkthatnowiresaretrapped
beforetighteningdowntherearframescrew.

Oncetherearframescrewissecure,inserta1/8”hexkeyintothe
frontframescrewholeintheforegripcrownandtightenthefront
screwintoplace
(SEEFIGURE22D) .
ConnectthesolenoidandBreakBeamSensorSystemwiring
harnessestotheirrespectiveportsontheGSLcircuitboardand
(SEE
FIGURE22E) .Adjustthewiressothattheysitneatlyinthegripframe
andensurethatthewiresdonotobstructeitherthemicro-switchor
theOptosensor
(SEEFIGURE22F) .

AttachtheGSLrubbergripstotheframeusinga5/64”hexkeyto
replacethefourgripscrews
(SEEFIGURE22G) .

ScrewtheinlineregulatorbackintotheFrontRegulatorMountand
connectanyhosingthatwasdisconnectedearlier
(SEEFIGURE22H) .

Youhavenowre-installedtheframeontotheGSL.
aTTaCHing THE FraME
IF YOU ARE UNSURE ABOUT PERFORMING A MAINTENANCE
PROCEDURE PLEASE CONTACT YOUR NEAREST SERVICE
CENTRE.
WARNING
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PAINTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
FIG22A
FIG22C
FIG22E
FIG22G
FIG22B
FIG22D
FIG22F
FIG22H
52 MainTEnanCE