Manual

Thisprocedureisonlyrequiredifyouaremaintainingtherearsection
ofthepropshaftassemblyduetoaleakcomingfromwithinthebolt
bonnetsubassemblyorfromthefrontofthebolt.Aftermaintaining
thefront14x2propshafto-ringand017internalcano-ring.
Firstlyremovetheboltsystemassembly,thenseparatetheboltcan
andpropshaftassembliesasdetailedonpages48-49.
Pushdownonthesplitinthedelrinretainingringandpullthe
retainingringoutofthepropshaftbackcap.
(SEEFIGURE20A) .
Removethepropshaftfromthebackcap,takingcarenottolosethe
propshaftspring,plungerorplungero-ring.
Checkthe14x2o-ringatthebackofthepropshaft,andcleanor
replacethenre-lubricatewithEclipseGreaseasnecessary.Check
therearbumperforsignsofwear,replaceasnecessary.
(SEEFIGURE
20B) .
Checkthe5x1o-ringseatedontheplunger,cleanorreplaceas
necessary.
Placetheplungerandspringwithinthepropshaft,withplungerdome
pointingawayfromthepropshaft
(SEEFIGURE20C) .
Replacethebackcapovertherearofthepropshaft,pushingthe
propshaftbackintothebackcap
(SEEFIGURES20D)
1
.
Compresstheretainingring
(SEEFIGURE20E) andpushtheretaining
ringintothebackcap.Theretainingringneedstositinits
designatedgrooveinthebackcap.Ifthepropshaftcanbepulled
outofthebackcapthentheretainingringhasnotseatedcorrectly.









1
If any o-rings or the bumper are damaged then replace them. Extra o-rings and bumpers are
available in parts kits available at www.planeteclipse.com
aDVanCED BoLT sYsTEM
MainTEnanCE
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PAINTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
FIG20A
FIG20B
FIG20C
FIG20D
FIG20E
FIG20F
50 MainTEnanCE