Manual

Removetherubberdetentandusingadrycottonbudcleanthe
detentanditslocationpointintheGSLbody,replacingthedetentif
itisdamaged
(SEEFIGURE15D) .
ReinsertthedetentbackintotheGSLbodyandplacetheBBSS
backintothedesignatedslotinthebody
(SEEFIGURE15E) .Ensurethat
thesensorisfacedowninthebodyi.e.lookingintothebreech.
1

Replacetheeyecoverandusinga5/64”hexkey,replacethe
retainingscrewtoholdtheeyecoverinplace
(SEEFIGURE15F) .
RepeattheprocedurefortheoppositesideoftheGSL.
YouhavenowcleanedyourBreakBeamSensorSystem.











1
Ensure that the receiver sensor (indicated by a red mark & red heat shrink) is located on the
right-hand side of the marker body.
(ConTinUED)
IF YOU ARE UNSURE ABOUT PERFORMING A MAINTENANCE
PROCEDURE PLEASE CONTACT YOUR NEAREST SERVICE
CENTRE.
WARNING
FIG15D
FIG15E
FIG15F
MainTEnanCE 43