Manual

UndotheretainingscrewfortheBreakBeamEyecoverontheleft
handsideoftheGSLusinga5/64”(2mm)hexkey (SEEFIGURE15A) .
RemovetheeyecovertoexposethebackoftheBreakBeamSensor
unit
(SEE FIGURE 15B) . Using a dry cotton bud, carefully remove any
debris, paintormoisture from thebackofthesensor unitandfrom
insidetheeyecover.
LifttheBreakBeamSensorunitfreefromtheGSLbodyandusing
anotherdrycottonbud,removeanygreaseordebrisbuild-upfrom
thefrontofthesensorunit
(SEEFIGURE15C) .
THE BrEaK BEaM sEnsor
sYsTEM
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PAINTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
FIG15A
FIG15B
FIG15C
42 MainTEnanCE