Manual

ThisparameterisusedtoselectthefiringmodeoftheGSLandhasthefollowingchoices:

>Semi:ThisisthedefaultandinthisfiringmodetheGSLwillfireoneshotforeverytriggerpull.
>RAMP:Inthisfiringmode,therateoffireisincreasedabovetherateatwhichthetriggerispulledoncecertaincriteriahave
beenmet.ThesecriteriaaresetbytheparametersontheRampSetupmenu.
1

>CANCEL:Editingiscancelledandtheparameterisunchanged.
TheROFCAPparameterisusedtospecifywhetherornottheGSLshouldhavealimited/cappedrateoffire.WhentheROF
CAPisenabled(andtheBBSSisenabled),themaximumachievablerateoffireissetbytheBSONROFparameter.Choicesfor
theROFCAPparameterare:

>OFF:Rateoffireonlylimitedbytheloader.
>ON:RateoffirelimitedtotheBSONROFparametervalue.
>CANCEL:Canceleditingandleavetheparameterunchanged.
1
Some presets and fire modes may only be available in certain countries and on some models of the GSL.
TheBSONROFparameterisusedtosetthemaximumachievablerateoffirefromtheGSL.Thevalueofthisparametercanbe
adjustedbetween4.0and30.0ballspersecondin0.1bpsincrements.
1


TheBSONROFparameterwillonlybedisplayedifyouhavesettheROFCAPparameterto‘ON’.
TheBSOFFROFparameterisusedtocontrolhowfasttheGSLcycleswhentheBreakBeamSensorSystemisdisabled.This
parametercanbesetbetween4.0and15.0ballspersecondandshouldalwaysbesettotheslowestspeedoftheloading
systeminuse.
1
1
Always calibrate your GSL ROF CAP parameters to the local field BPS meter as readings may vary from meter to meter.
1
Always calibrate your GSL ROF CAP parameters to the local field BPS meter as readings may vary from meter to meter.
FirE MoDE ParaMETEr
roF CaP ParaMETEr
Bs on roF ParaMETEr*
Bs oFF roF ParaMETEr
30 aDVanCED sETUP