Manual

THE soUnD inDiCaTor
THE TriggEr DETECTion inDiCaTor
Inorderforthetriggertobesuccessfullyoperateditmustfirstbereleasedandthenpulled.Thetriggerdetectionindicator(TDI)isusedto
indicateeachofthepossibletriggerstates.
FromthefactorytheGSLwillhavetheOPTOsensorenabled.The
micro-switchcanbeenabledfromtheHardwaremenu(seepage37).
ThesoundindicatorontherunscreenisusedtoconveyiftheSoundparameterintheHardwaremenu(page37)isswitchedonoroff.
Therearetwopossibleconditionsthatcanbeindicated:
SOUNDENABLED
Thesoundparameterisenabled.TheGSLwillmake
soundswhenswitchedonandoffandwhenthegame
timeralarmsortimesout.
SOUNDDISABLED
Thesoundparameterisdisabled.TheGSLwillnotmake
anysounds.
MICRO-SWITCHSELECTED,NOTACTUATED
TheGSLisconfiguredtousethemicro-switchtodetect
triggerpulls.Themicro-switchisnotcurrentlyactuated,
i.e.thetriggerisreleased.
MICRO-SWITCHSelected,ACTUATED
TheGSLisconfiguredtousethemicro-switchtodetect
triggerpulls.Themicro-switchiscurrentlyactuated,i.e.
thetriggerispulled.
OPTOSENSORSELECTED,READINGABOVEPULL
POINT
TheGSLisconfiguredtousetheOPTOsensortodetect
triggerpulls.TheOPTOsensoriscurrentlyreadingabove
theOPTOpullpoint,i.e.thetriggerisconsidered‘pulled’.
OPTOSENSORSELECTED,READING0%
TheGSLisconfiguredtousetheOPTOsensortodetect
triggerpulls.TheOPTOsensoriscurrentlyreading0%,i.e.
thetriggerisfullyreleased.
OPTOSENSORSELECTED,READING100%
TheGSLisconfiguredtousetheOPTOsensortodetect
triggerpulls.TheOPTOsensoriscurrentlyreading100%,
i.e.thetriggerisfullydepressed.
OPTOSENSORSELECTED,READINGBELOWRELEASE
POINT
TheGSLisconfiguredtousetheOPTOsensortodetect
triggerpulls.TheOPTOsensoriscurrentlyreadingbelow
theOPTOreleasepoint,i.e.thetriggerisconsidered
‘released’.
OPTOSENSORSELECTED,READINGMID-RANGE
TheGSLisconfiguredtousetheOPTOsensortodetect
triggerpulls.TheOPTOsensoriscurrentlyreading
somewherebetweentheOPTOreleasepointandthe
OPTOpullpoint,i.e.thetriggerishalfdepressed.
24 Using THE gsL