Manual

Usinga5/32”hexkeyoryourfingers,turnthesprocketscrewofthe
clampingfeedtubecounter-clockwise (SEEFIGURE8A) .

Releasetheclampingleveronthefeedtube
(SEEFIGURE8B) andtest
toseeifyourloadercaneasilybepushedintothetopofthefeed
tube.Iftheloadercannoteasilybepushedintothefeedtube,loosen
thesprocketscrewoftheclampingfeedtubealittlemorebyturning
itcounter-clockwiseusinga5/32”hexkeyoryourfingers
(SEEFIGURE
8A) .

Whenyouhavemanagedtopushyourloaderintotheclampingfeed
tube,closetheclamptosecureitfirmlyinplace
(SEEFIGURE8C) .Ifthe
loaderisloosethenyouwillneedtoreleasetheclamp,tightenthe
sprocketscrewslightlybyturningitclockwisewitha5/32”hexkeyor
yourfingersandclosetheclamp.Repeatthisprocessasnecessary
tosecureyourloaderinplace.

YouhavenowattachedaloadertoyourGSL.Onceyouhavefilled
yourloaderandairtankyouwillthenbereadytobeginusingyour
GSL.
aTTaCHing a LoaDEr
DO NOT OVER TIGHTEN THE CLAMPING FEED TUBE AS
THIS MAY DAMAGE THE LOADER OR FEED TUBE ITSELF.
WARNING
FIG8A
FIG8B
FIG8C
14 Using THE gsL