Manual

EveryGSLcomescompletewithanEclipseSL3Shaftbarrel(see
page70).TheboresizeoftheSL3Shaftbarrelbackisengravedon
thebarrelbackjustinfrontofthebodythreads.
ToinstalltheSL3Shaftbarrel,firstlyscrewthebarreltipandbarrel
backsectionstogether.ThethreadsontheSL3Shaftbarreltipare
reversethreaded.Toscrewthetwosectionstogether,withthebarrel
pointingawayfromyou,turnthebarreltipinaclockwisedirection
(SEEFIGURE6A) .
WhilepointingtheGSLmarkerinasafedirection,insertthe
assembledSL3ShaftbarrelintothefrontoftheGSLbodyandscrew
theSL3ShaftbarrelintotheGSL(inacounter-clockwisedirection).
ContinuetoscrewtheSL3ShaftbarrelintotheGSLbodyuntilthe
barrelbecomessnuginthebody
(SEEFIGURE6B) .DONOTover
tightenthebarrel.
InstallabarrelblockingdeviceoverthebarrelsuchastheEclipse
barrelsock
1
suppliedwiththeGSL (SEEFIGURE6C) .
2
Youhavenow
installedthebarrel.







1
The Eclipse Barrel Sock that comes with the GSL may differ from that pictured in this manual.
2
Instruction on using the Eclipse Barrel Sock can be found on the Eclipse Barrel Sock warning
label.
insTaLLing a BarrEL
MAKE SURE THE MARKER IS TURNED OFF AND THAT NO
PAINTBALLS ARE IN THE MARKER OR LOADER BEFORE
INSTALLING A BARREL.
WARNING
FIG6A
FIG6B
FIG6C
Using THE gsL 11