Manual

43
GEO:CS1
FAULT FINDING
FAULT FINDING TABLES
If an issue with the CS1 cannot be solved using the fault nding guide,
contact your nearest Eclipse Service Centre for assistance.
SYMPTOM POSSIBLE CAUSE SOLUTION
The breech sensor defaults after ring.
The breech sensor is dirty. Clean the breech sensor.
The breech sensor is faulty. Replace the breech sensor.
The breech sensor is out of place. Re-install the breech sensor then check the alignment.
On power up, the right hand side of
the screen is not displayed and the
marker will not re.
The trigger is permanently depressed.
Adjust the trigger until the selected trigger detection method
is de-activated when the trigger is released.
The CS1 does not re.
The CS1 is not powered on.
Power up the CS1 using the button on the back of the
CS1 grip frame.
The POPS is not fully engaged. Pull the POPS bonnet back until it engages.
The battery quality or charge level is very low. Install new high quality alkaline or lithium batteries.
The batteries are at. Replace the batteries.
The DWELL parameter is set too low. Increase the DWELL parameter.
The trigger is set-up incorrectly.
Adjust the trigger correctly to fully open and close the
micro/opto switch.
The solenoid is not plugged into the CS1 body PCB. Plug the solenoid wire into port on the CS1 body PCB.
The BS is enabled and there is no paint in the breech.
Fill the loader with paint.
Check that the rubber bolt tip is seated correctly.
The PCB is damaged. Replace the PCB.
The solenoid valve is damaged. Replace the solenoid valve.