Manual

FIG-1
FIG-3
FIG-2
FIG-4
32
GEO:CS1
ELECTRONICS
USER INTERFACE PARAMETERS
FIG-1 - TRAINING PARAMETER
This simulates the ring cycle (in unloaded state)
using a BEEP on each trigger pull, so the user can
practice their trigger technique o the eld.
> ON: TRAINING mode enabled.
> OFF: TRAINING mode disabled.
> CANCEL: Editing is cancelled and unchanged.
FIG-2 - SHOT COUNT MENU
This menu controls controls the shot counter parameters.
FIG-3 - GAUGE PARAMETER
This toggles the visibility of the gauge graphic in
the shot counter on the run screen.
> ON: GAUGE graphic enabled.
> OFF: GAUGE graphic disabled.
> CANCEL: Editing is cancelled and unchanged.
FIG-4 - GAUGE MAX PARAMETER
This sets the number that the gauge counts down from every time the CS1 is red.
This parameter can be set between 100 and 2000 in increments of 10.