Manual

FIG-1

FIG-3

FIG-2

FIG-4

GEO:CS1

ELECTRONICS

USER INTERFACE PARAMETERS

FIG-1 - SEMI SHOTS PARAMETER

This sets the number of shots in semi-automatic required at the KICK IN rate before ramping starts.

This parameter can be set between 3 and 9 pulls in 1 pull increments.

FIG-2 - KICK IN PARAMETER

This sets the maximum rate at which the user has to pull the trigger to start ramping.

This parameter can be set between 3.3 and 10.0 pulls per second in 0.1 pulls per second increments.

FIG-3 - SUSTAIN PARAMETER

Whilst ramping, this sets the rate at which the user must continue to pull the trigger to maintain ramping.

This parameter can be set between 3.3 and 10.0 pulls per second in 0.1 pulls per second increments.

FIG-4 - RESTART PARAMETER

This denes the amount of time that elapses, after the nal ramped shot is red before ramping will begin

again after 1 trigger pull. If the RESTART time expires, the other ramping conditions must be met.

This parameter can be set between 0.0 and 1.0 seconds in 0.1 second increments.