Manual

15
GEO:CS1
FIG-1
A
Ensure that a barrel blocking device is tted for safety.
B
Switch the marker o.
C
De-gas the marker.
Push in and hold the POPS button and pull the POPS bonnet away
from the POPS body.
D
Remove the pre-set air system.
Unscrew the air system counter-clockwise from the POPS body.
E
Loosen the clamping feed neck.
Open the feed neck lever away from the feed neck.
Unscrew the feed neck lever screw counter-clockwise.
F
Remove the loader.
If the feed neck is too tight, loosen the clamping feed neck screw.
G
Remove the barrel from the marker body.
Unscrew the barrel counter-clockwise to remove.
H
Remove the barrel tip from the barrel back.
Unscrew the barrel tip clockwise to remove.
1
IMPORTANT! Extra precaution to avoid injury.
2
IMPORTANT! To switch O/On, see page 08.
3
IMPORTANT! Always de-gas before unloading.
4
IMPORTANT! Always remove air system before unloading.
5
IMPORTANT! Always remove any paintballs from the breech of the
marker once the loader has been removed.
6
IMPORTANT! Unscrew the barrel tip CLOCKWISE.
QUICK START
UNLOADING THE CS1
WARNING!
Always make sure the marker is O with a barrel blocking device installed and
that no paintballs are in the CS1 breech or loader before unloading.
Compressed air and nitrogen systems can be extremely dangerous if handled
or used incorrectly.
NEVER leave the CS1 gased up when unloading.
NEVER point your marker in the direction of other people when not on the eld.
Remove any paintballs from the breech before storing your CS1.
WARNING