Manual

FACTORY SET-UP GUIDE
Before using the Geo3 it is important to make sure
the SL3 inline regulator, solenoid flow restrictor (SFR)
and all electronically controlled parameters are set
correctly. All of these can have a negative effect on the
performance of the marker if incorrectly set.
The steps below will restore the Geo3 settings to the
factory settings. These settings will give the Geo3 a
more balanced performance, ideal for the average user.
-Check the inline regulator adjuster screw is set to
4
1/2
turns clockwise from its maximum out (counter-
clockwise) position
(see figure 3A). This will ensure
the inline regulator is set to an output pressure that will
not damage the Geo3 when supplied with compressed
air/nitrogen (see page 25 for more information on the
inline regulator).
-Check that the SFR is set to maximum (indicator
pointing upwards)
(see figure 3B). Use a 5/64”
(2mm) hex key to adjust the SFR. See page 26 for more
information on the solenoid flow restrictors.
-Load the Factory preset stored on the Geo3 circuit
board. This preset will restore all the electronic
parameters to their default settings. See page 40 on
loading the Factory preset.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
WARNING
FIG 3A
FIG 3b
8.
QUICK SET-UP