Manual

The Break Beam Sensor System is not
reading at all.
Two or more balls are being fed into the
breech.
Geo3 is inconsistent.
Geo3 is ineffeceint
Break Beam Sensor System turns itself off
after firing.
When the Geo3 powers up,, the right hand
side of the screen is not displayed and the
marker will not fire
The Geo3 degasses very slowly.
Geo3 has low rate of fire
There is a broken wire or contact, or a short
circuit on either of the Breech Sensor cables.
Either sensor is back to front.
Detents are broken/missing
Loader feed force is set too high
Dwell parameter set too low.
Solenoid Flow Restrictor (SFR) set too low.
Poor quality paintball
Poor paintball to barrel bore match.
inline regulator is supercharging.
Dirty body filter.
Poor air supply into POPS
Dwell is excessively high.
Eye is dirty.
Eye is faulty.
Eye is out of place.
The trigger is permanently depressed.
The body filter is blocked / damaged
Solenoid flow restrictor is set too low.
Check the plug of the cables.
Check for cuts or pinches in the sensor cables.
Check that the sensors face each other when
installed.
Change the rubber finger detents.
Reduce the feed force on the loader.
Increase the Dwell parameter.
Increase the flow through the SFR.
Use better quality paintballs
Use a better paintball to barrel bore size match.
Strip and clean inline regulator.
Strip and clean the body filter.
Use a good quality preset air system
Reduce the Dwell.
Clean the eyes.
Replace the eyes.
Re-Install Eyes. Check alignment.
Adjust the trigger until the selected trigger
detection method is activated when the trigger
is released.
Clean the body filter and inspect for damage.
Replace if damaged.
Increase the amount of flow on the SFR.
SYMPTOM POSSIbLE CAUSE SOLUTION
74.
FAULT FINDING