Manual

(CONTINUED)
Clean and check the condition of the single internal
005 NBR90 o-ring in the front of the POPS Insert, replace
if necessary
(SEE FIGURE 26I). Lubricate this o-ring
liberally using Eclipse Grease.
Lubricate the narrow end of the POPS Pin with a smear
of Eclipse Grease and push the Pin, narrow end first,
into the POPS Insert so that it sits in the POPS Insert
and pokes through to the front
(SEE FIGURES 26J &
26K)
.
Screw the POPS Insert back into the POPS body ensuring
that the o-ring end goes in first
(SEE FIGURE 26G).
Replace the Push Rod into its designated slot
(SEE
FIGURE 26L)
, then side a 004 NBR70 O-rings on both
ends of the Push Rod. Make sure the Push Rod is centred
in the POPS body
(SEE FIGURE 26M).
Slide the bonnet over the POPS body and align the hole
on the bonnet with the front hole on the POPS body
(SEE
FIGURE 26N)
.
Ensure the Latch Button and Spring are attached to each
other then slide them both into the POPS body through
the hole in the bonnet, spring end first, making sure the
Latch Button pokes out the right side of the bonnet
(SEE
FIGURE 26O)
.
Push the Button down as far as it will go, then (while still
holding down the Button) slide the bonnet back until the
Button engages with the POPS body and cannot slide into
the forward position
(SEE FIGURE 26P). Reconnect
the Macroline hose to the fitting on the POPS body.
You have now successfully cleaned and maintained your
Push Operated Purge System.
FIG 26J
FIG 26L
FIG 26N
FIG 26P
FIG 26I
FIG 26K
FIG 26M
FIG 26O
WARNING: IF YOU ARE AT ALL UNSURE AT
PERFORMING THE MAINTENANCE PROCEDURE
PLEASE CONTACT YOUR NEAREST ECLIPSE SERVICE
CENTRE. (SEE PAGE 75)
WARNING
70.
MAINTENANCE